intTypePromotion=1
zunia.vn Tuyển sinh 2024 dành cho Gen-Z zunia.vn zunia.vn
ADSENSE

Steady state error

Xem 1-6 trên 6 kết quả Steady state error
  • Lecture "Fundamentals of control systems - Chapter 5: Analysis of control system performance" presentation of content: Performance criteria, steady state error, transient response, the optimal performance index,... Invite you to reference.

    pdf0p doinhugiobay_17 04-03-2016 61 4   Download

  • Lecture Control system design: Feedback control system characteristics presents the following content: Error signal analysis, sensitivity of control systems to parameter variations, disturbance signals in a feedback control system, control of the transient response, steady – state error, the cost of feedback, control system characteristics using control design software.

    pdf32p youcanletgo_04 17-01-2016 55 2   Download

  • This chapter presents the following content: Test input signals, performance of second – order systems, effects of a third pole & a zero on the second – order system response, the s – plane root location & the transient response, the steady – state error of feedback control systems, performance indices, the simplification of linear systems, system performance using control design software.

    pdf56p youcanletgo_04 17-01-2016 69 3   Download

  • Tuyển tập báo cáo các nghiên cứu khoa học quốc tế ngành hóa học dành cho các bạn yêu hóa học tham khảo đề tài: Research Article Analysis of Transient and Steady-State Behavior of a Multichannel Filtered-x Partial-Error Affine Projection Algorithm

    pdf15p sting11 09-03-2012 50 3   Download

  • Typical dynamic responses are also shown. The motor is initially at standstill and at no load when a step command in speed is applied; when steady-state conditions are reached, a reversal of speed is commanded followed by a step load application. The system is highly nonlinear due to the introduction of saturation needed to limit both the current delivered and the voltage applied to the motor.

    doc20p meoden89nd 15-01-2011 199 39   Download

  • -Thiết kế mô phỏng là quá trình thiết kế với sự trợ giúp của máy tính và các phần mền ứng dụng chuyên nghiệp. -Các từ khóa được sử dụng trong thiết kế mô phỏng: Simulation, process simulation : Mô phỏng, quá trình mô phỏng Dynamic simulation : mô phỏng động Simulator : thiết kế mô phỏng Equation of state (EOS) : phương trình trạng thái Steady-state simulation : mô phỏng trạng thái bền vững To proceed by trial and error : Mô phỏng bằng cách mò mẫm Model : mô hình Modelling : quá trình mô hình hóa...

    pdf62p nguyenthovt 05-01-2011 349 132   Download

CHỦ ĐỀ BẠN MUỐN TÌM

TOP DOWNLOAD
ADSENSE

nocache searchPhinxDoc

 

Đồng bộ tài khoản
2=>2